beside the WiFi symbol. Is there a command I can run to try to fix it? I’ve done a hard reset already and no luck.Netgear Mr6500 fail to broastcast wifi evenif broastcast ssid enabled already.
-
ZzzzShinzzzZ
- Posts: 3
- Joined: Thu Feb 15, 2024 8:21 pm
- Has thanked: 1 time
- Been thanked: 0
Netgear Mr6500 fail to broastcast wifi evenif broastcast ssid enabled already.
Has anyone encountered this issue on their Nighthawk hotspot before? It’s an unlocked MR6500, works fine via Ethernet and USB tethering, but will not broadcast WiFi it has 
beside the WiFi symbol. Is there a command I can run to try to fix it? I’ve done a hard reset already and no luck.
beside the WiFi symbol. Is there a command I can run to try to fix it? I’ve done a hard reset already and no luck.-
BillA
- Posts: 1152
- Joined: Sun Dec 01, 2019 6:46 pm
- Location: USA
- Has thanked: 208 times
- Been thanked: 318 times
- Contact:
Re: Netgear Mr6500 fail to broastcast wifi evenif broastcast ssid enabled already.
ZzzzShinzzzZ wrote: ↑Thu Feb 15, 2024 8:31 pm Has anyone encountered this issue on their Nighthawk hotspot before? It’s an unlocked MR6500, works fine via Ethernet and USB tethering, but will not broadcast WiFi it has
Try a factory reset using the hardware method.
https://kb.netgear.com/9665/How-do-I-pe ... EAR-router
Set up it again and see if WiFi is broadcasting, if not then probably the WiFi chip is fried.
