Wireless Joint

Been pulling my hair out all week, tried all settings found here and those at the visible website, even ordered a new sim and still wont connect, only thing I haven't tried is AT Commands cause I have no clue how and where you do it from

AT commands on the LT500: http://192.168.10.1/cgi-bin/luci/admin/network/gcom/atcmd

Tried no change, I think i just got a bad router, tried a netgear LM1200 and connected fine, Cudy refunded my $$ and told me to keep it
Whats the command for QMI? AT+QCFG="usbnet",0?

ChrisW wrote: ↑Thu Dec 16, 2021 5:36 pm Tried no change, I think i just got a bad router, tried a netgear LM1200 and connected fine, Cudy refunded my $$ and told me to keep it
Whats the command for QMI? AT+QCFG="usbnet",0?

yep except no ? mark

I also tried a Yeacomm and connected to Visible fine, just cant get around the 5mbps limit wireless, hardwired is fine, TTL settings have no effect

I'm having the same issue with the yeacomm and I'm glad you posted this because I've also tried every ttl there is and no change whatsoever.

ChrisW , allica2002

Just noticed yesterday we are now throttled at 5mbps up and down with Visible.
This is setup inside a Debian Linux PC iptables,,and our setup has worked fine no throttling for 5 months now.
Was getting around 45mbps down and 30mbps up.
Seems none of the TTL settings aren't doing anything now.
Have either of you found anything in regards to Visbile,as of now?

Thanks

might be worth mentioning one of the resident GURUS, like @Didneywhorl.

to be honest, I've never more than 15mbps consistently. i'd be interested in figuring that out, but its not high up on the to-do list these days... since my connection "just works" for now, I'm hesitant to mess with a good thing.

todays middling performance below...