Like the subject reads I am looking for some kind of AT command that will show me SINR. Something like atstatus but for the ep06-a.
Wifix shows ecio but thats not really the same thing.
At command EP06 to show SINR
Forum rules
Use the SEARCH function for related topics PRIOR to posting a new topic on the same subject.
Use the SEARCH function for related topics PRIOR to posting a new topic on the same subject.
Re: At command EP06 to show SINR
Hello,
Try looking into these commands see if it gives you what you are looking for.
AT+QENG="servingcell" < which is the equivalent of Sierra's AT!GSTATUS?
AT+QENG="neighbourcell" < which is the equivalent of Sierra's AT!LTEINFO
Try looking into these commands see if it gives you what you are looking for.
AT+QENG="servingcell" < which is the equivalent of Sierra's AT!GSTATUS?
AT+QENG="neighbourcell" < which is the equivalent of Sierra's AT!LTEINFO
Re: At command EP06 to show SINR
i dont see anything in here that appears to be SINR
+QENG: "servingcell","NOCONN","LTE","FDD",311,480,2A1DF24,113,2450,5,3,3,AC0B,-100,-13,-71,13,-
that said I have no idea what a few of those numbers relate to specifically the 2450,5,3,3 the rest I think I can kinda figure out
Looking up that command it doesnt appear to contain SINR
From the pdf
In the case of LTE mode:
+QENG: "servingcell",<state>,"LTE",<is_tdd>,<mcc>,<mnc>,<celli d>,<pcid>,<earfcn>,<freq_band_ind>,<ul_bandwidth>,<dl
+QENG: "servingcell","NOCONN","LTE","FDD",311,480,2A1DF24,113,2450,5,3,3,AC0B,-100,-13,-71,13,-
that said I have no idea what a few of those numbers relate to specifically the 2450,5,3,3 the rest I think I can kinda figure out
Looking up that command it doesnt appear to contain SINR
From the pdf
In the case of LTE mode:
+QENG: "servingcell",<state>,"LTE",<is_tdd>,<mcc>,<mnc>,<celli d>,<pcid>,<earfcn>,<freq_band_ind>,<ul_bandwidth>,<dl
-
Didneywhorl
- Posts: 3616
- Joined: Fri Mar 23, 2018 5:37 pm
- Location: USA
- Has thanked: 1363 times
- Been thanked: 756 times
- Contact:
Re: At command EP06 to show SINR
Must be an old manual, this is from my manual:
You do not have the required permissions to view the files attached to this post.
