Page 1 of 1
Problems with TTL settings on gl-mt300n-v2 using Visible
Posted: Wed Apr 21, 2021 2:11 pm
by Impressive_squirrel
Hi everyone! I'm new here and I'm having some trouble with my Mango. I have my phone tethered to it via USB and I've put in the custom TTL settings in the firewall, I get good speeds on my laptop usually 30mbps and sometimes even above 60, but when I connect it to my ps4 I can never get past 2.4mbps for some reason. I've tried everything, I've tried so many TTL settings, I've used 65,64,117 and it seems like I'm still being throttled somehow and I honestly do not understand why. Any help would be GREATLY appreciated.
Re: Problems with TTL settings on gl-mt300n-v2 using Visible
Posted: Wed Apr 21, 2021 9:20 pm
by Didneywhorl
So your phone is also Visible?
Re: Problems with TTL settings on gl-mt300n-v2 using Visible
Posted: Thu Apr 22, 2021 1:12 pm
by Impressive_squirrel
Yes it is
Re: Problems with TTL settings on gl-mt300n-v2 using Visible
Posted: Thu Apr 22, 2021 6:13 pm
by Dr-BroadBand
Found this it's for a PS5 but may help.
Well, I found my issue. Within the PS5 internet settings, I changed the mtu to 1473 and it cleared my issue.
Also found this for PS4
https://www.dualshockers.com/ps4s-tempo ... al-by-sony
https://weakwifisolutions.com/does-chan ... on-the-ps4
In networking
MTU stands for Maximum Transmission Unit and dictates the maximum size for any packet of data that is sent from a device over a network. MTU is measured in bytes and has a maximum value of 1500, so an MTU of 1500 dictates that the largest packet of data that can be sent in one go from a device over a network is 1500 bytes.
Re: Problems with TTL settings on gl-mt300n-v2 using Visible
Posted: Fri Apr 23, 2021 9:30 am
by Impressive_squirrel
Dr-BroadBand wrote: ↑Thu Apr 22, 2021 6:13 pm
Found this it's for a PS5 but may help.
Well, I found my issue. Within the PS5 internet settings, I changed the mtu to 1473 and it cleared my issue.
Also found this for PS4
https://www.dualshockers.com/ps4s-tempo ... al-by-sony
Thank you so much! I tried changing the MTU but speeds are still 2.2 and below with both MTU settings. I also see at the bottom there's a message that says "Router in use may not support IP packet fragmentation" any clue as to what might be happening there?
https://weakwifisolutions.com/does-chan ... on-the-ps4
In networking
MTU stands for Maximum Transmission Unit and dictates the maximum size for any packet of data that is sent from a device over a network. MTU is measured in bytes and has a maximum value of 1500, so an MTU of 1500 dictates that the largest packet of data that can be sent in one go from a device over a network is 1500 bytes.
Re: Problems with TTL settings on gl-mt300n-v2 using Visible
Posted: Fri Apr 23, 2021 11:03 am
by Dr-BroadBand
Sounds like you need to up your game on the hardware