I bought a em12-g modem and a nexq6go router and the router sees the modem but wont connect to a page plus sim that works fine in a mr1100 and a mofi 4500, changed the com ports to usb 1 and 2 and set ttl to 64,65, 117 used apn for pageplus
nothing works ran at signal command getting 22 , 99 . It sees the sim getting my telephone number etc but just wont connect ,
Please Help.
EM12-2 router and nexq6go connection problems
Forum rules
Please assure there is not an existing forum and topic related to your post
Please assure there is not an existing forum and topic related to your post
Re: EM12-2 router and nexq6go connection problems
You do not need to change your COM port with the EM12-G with the WiFiX firmware. In fact, you can disrupt its ability to properly communicate with the AT command COM port.
I would go to the Firmware Backup/Restore, and set the WiFiX firmware to its defaults settings.
Then, when it booted back up, set the APN (Save and Apply) and the TimeZone, and hard reboot the router.
While I am not familiar with pageplus, resetting the firmware would be my initial starting point.
I would go to the Firmware Backup/Restore, and set the WiFiX firmware to its defaults settings.
Then, when it booted back up, set the APN (Save and Apply) and the TimeZone, and hard reboot the router.
While I am not familiar with pageplus, resetting the firmware would be my initial starting point.
- Didneywhorl
- Posts: 3635
- Joined: Fri Mar 23, 2018 5:37 pm
- Location: USA
- Has thanked: 1369 times
- Been thanked: 761 times
- Contact:
Re: EM12-2 router and nexq6go connection problems
PagePlus, in my limited experience, isnt super thrilled about device hopping the SIM. You may want to get a new SIM for your device.
Try doing as bjames said above first.
Try doing as bjames said above first.
- Didneywhorl
- Posts: 3635
- Joined: Fri Mar 23, 2018 5:37 pm
- Location: USA
- Has thanked: 1369 times
- Been thanked: 761 times
- Contact: