Noob Questions 5G RM500Q-GL

Post Reply
biorchang
Posts: 10
Joined: Fri Dec 09, 2022 4:33 pm
Has thanked: 1 time
Been thanked: 0

Noob Questions 5G RM500Q-GL

Post by biorchang »

Hi all.

Just finished compiling OpenWRT for my Raspberry Pi 4b and have a PiHat installed with a Quectel RM500Q-GL.

I can see the modem listed on my USB2 interface with DMESG, but think I need an activated SIM before I can use minicom to query and then setup in LUCI?

Any tips on where I can find the AT commands for this modem and which US carriers I could try out? I'm a part time RV'er...so looking for a monthly unlimited plan that I could pause and only use when I'm on the road.

I understand 5G may not be fully supported, so happy with 4G/LTE at this point.

Thanks for the help!
biorchang
Posts: 10
Joined: Fri Dec 09, 2022 4:33 pm
Has thanked: 1 time
Been thanked: 0

Re: Noob Questions 5G RM500Q-GL

Post by biorchang »

Ah...just found the AT command reference :D
biorchang
Posts: 10
Joined: Fri Dec 09, 2022 4:33 pm
Has thanked: 1 time
Been thanked: 0

Re: Noob Questions 5G RM500Q-GL

Post by biorchang »

Ok. I think I may need a driver loaded?

Here is dmesg output:

[ 34.357552] usb 2-1: new SuperSpeed USB device number 2 using xhci_hcd
[ 34.390751] usb 2-1: New USB device found, idVendor=2c7c, idProduct=0800, bcdDevice= 4.14
[ 34.398950] usb 2-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 34.406086] usb 2-1: Product: RM500Q-GL
[ 34.409932] usb 2-1: Manufacturer: Quectel
[ 34.414026] usb 2-1: SerialNumber: ******
[ 34.424599] usb 2-1: Enable of device-initiated U1 failed.
[ 34.430918] usb 2-1: Enable of device-initiated U2 failed.
Post Reply

Return to “Raspberry Pi”