http://www.aturnofthenut.com/autobuilds/ZBT-WE826T-GO2022-09-08-AB19.zip

I'd try this one.

Thanks! Which firmware should I flash? I have seen so many, I am getting lost. Thanks for providing me with a link.
Cheers

hydrocynus wrote: Sun Sep 04, 2022 9:03 am Does this work on a WE826-T2?

The Process does, yes.

Does this work on a WE826-T2?

... of the following currently:

- 11 down/0.8 up DSL (currently not being used at all and I'll probably drop it if I add another LTE connection)

- WE1326 router and EM7565 modem. The router is in an external enclosure purchased from The Wireless Haven. It is on a 10 foot pole on the roof, on an old ...

Thank you for all your help

Hello, the WiFix link seems to be down (https://thewirelesshaven.com/wifix-router-firmware/) Thank you!

... m sure monthly bandwidth would have eventually come into play.

Now that its all said and done, I have 2 WAN connections. 1) ATT+WE826 and 2) ATT+WE1326. Those 2 are load balanced and ran to my main netgear home router to run the house. Off to the side and completely separate from that I have both ...

... 0;+CFUN=1,1 versus AT!RESET to reset the modem? I see the steps above to use RESET and comment out CFUN, but /usr/lib/custom/johns_ping.sh on my WE1326 GoldenOrb_2019-04-09 has AT!RESET commented out and uses the CFUN command to reset the modem.
My modem will not connect back to the router after a ...

Something not mentioned here is that the bootloader runs on http and not https. Most cases luci-ssl is enabled and neither chrome or firefox will switch between them automagically.

If you're getting pings from the router but can't access luci or the bootloader check the address bar and make sure ...

To back up what Jim said, I recently put together a WE1326 and an EM7565. I'm using the generic firmware that came with the modem and the latest WiFiX firmware for the router. I haven't enabled the connection monitor and haven't noticed any problems so far. I've had it on for about 24 hours at a time ...

I find running a continuous ping against 192.168.1.1 is a good way to know when to release the reset button in step 7. Release as soon as there is a ping response from 192.168.1.1.

I sure wish I'd found this site before I bought this batch of routers. I found Wireless Joint trying to figure out all the problems with my AliExpress units and the ones in the shop here are actually cheaper, have the right modems, the right antennas and high amperage power supplies so we don't drop ...

This really helped me out. I purchased a ZBT WE826-T2 from AliExpress and it had an OEM firmware that wouldn’t let me connect to AT&T or T-Mobile. I followed the “default” steps here, on GoldenOrb and OpenWRT and kept getting a chinese error message that said the firmware was invalid. This little ...

This tutorial will demonstrate the process of flashing the firmware on the WE826-T router. The procedure is the same for other WE | WG LTE routers with the only difference is selecting the correct firmware for the router.

The WE|WG series of routers are loaded with OpenWRT firmware. Some users may ...

... times, develops a sort of touch to the timing. In short, be patient. The method will work.

In the event your boot loader screen comes up in Chinese, see this TOPIC

FIRMWARE:

WiFiX custom GoldenOrb firmware

All GoldenOrb firmware builds

WE826 | WG3526 | WE1326 | WE1026-5G OEM OpenWRT firmware