Wireless Joint

I think a 1-15K resistor would make a good protection just in case (it's TTL lines so there's no high Amps there). Plus it would allow switching between the modes easily by simply covering or removing the pin cover. I'm just a bit confused about the modes, so with the pin covered and a short or res...

Reading the translated 4PDA thread, not sure if this is the right method... correct me if I'm wrong. https://4pda-to.translate.goog/forum/index.php?showtopic=994474&st=47960&_x_tr_sl=ru&_x_tr_tl=en&#entry129097775 That's right, on the front side of the module there are odd pins from...

Hello guys, to enable USB 2.0, I do not recommend soldering a jumper; it is better to solder a 10-15k resistor 0402. https://4pda.to/forum/index.php?showtopic=1086317&view=findpost&p=129461423 If you solder the jumper and poorly insulate pin 3, you can burn the modem. If you solder a resisto...

Deleted

Deleted

Hello! Does anyone have a document with AT commands for Fibocom FM350-GL?

Hogwild wrote: ↑Wed Sep 06, 2023 4:00 pm Rich had kindly offered to try to build a firmware file.

Do you have a working method of writing MR2100 partitions in EDL mode?

Hey guys, what are you trying to do? And most importantly - why?
You can load the MR2100 into the EDL mode without disassembling the case.
Or do you have some kind of hardware problem?