Wireless Joint

I also see unsupported protocol type on wan2 when the sims are swapped and fail load balancing.

I have successfully enabled load balancing on build GoldenOrb_2018-07-24 OpenWrt 18.06.0-rc2. I have also encountered a few interesting quirks that don't make any sense. The 2 providers I am load balancing are sprint (calyx) and att (tablet sim). After much troubleshooting, the real solution I found...

Thank you for info about the killall issue Jim. I will dig in the rooter forum to see if any solutions are presented. I did try "Enable Load Balancing at Connection" checked on/off for both modems at the time on GoldenOrb_2018-05-24 with 2 mc7455's. One variable that I wanted to make sure ...

New problems have popped up after following the of modems and men load balancing guide. If I plug in the usb modem adapter while the WG3526-P is powered on, the router will pick up the 2nd modem, but after a few minutes the 1st modem will go into a reconnecting loop. (both modems work fine separatel...

Thank you for the input. I was not aware the usb on the WG3526 was capable of hosting another modem. I will purchase the necessary parts and try this route.

I have encountered a hiccup on my plans of 1:1 load balancing 2 isp's on two WG3526-P routers. I planned to piggyback from router 1 lan to router 2 wan port and then run one ethernet cable to in house switch. Since the Wan port must be used for poe, does this make load balancing by this method null ...