Wireless Joint

I have an EM20-G, currently running on an ATT plan, but will be switching to Verizon. I would like to "repair" my modem IMEI so that it matches the phone I will utilize to activate a Verizon plan. My understanding is that it is possible with this modem (AT command??). Is there additional i...

LoveMeSomeCALTE wrote: ↑Mon Jul 06, 2020 1:11 am Well because you you have the Quectel in this case, you can "fix" the issue. THAT'S the most we can probably discuss on the forum openly, so you are still good.

How can I get more info on doing this?

success! Received the EM20 today and installed, adding the additional 2 antennas for the 4X4 MIMO. Powered on and the router/modem connected to cell tower and I now have internet. Getting about double the bandwidth as compared to my S9, signal is pretty weak here, but got up to 12Mbs vs around 4 wit...

Tracking all, again, thanks!

Apologize for another question, but better to confirm now. Are the pigtails that the EM20 uses the same as the EM7565 (Pigtails: 2 x MHF4 to SMA Female Bulkhead 1.13 Pigtails)?

Could not find anything in searches....

Thanks, think that should do it for the replacement modem!

Assume I can set the TTL through the WiFix firmware (custom TTL to 65) as well?

Thank you!

Additional info: This is for an AT&T unlimited plan SIM activated on an S7.

Thanks in advance....

Working on an RMA of EM 7565 due to the antenna post separating from the modem board. I decided to upgrade to the Quectel EM20-G from the store, it is on the way. Upgraded the H71 to the WeFix Firmware (WiFiX-m2m-nexg-GO2019-12-23-upgrade). If I read correctly, the Quectel drivers are included in th...

Also, apologies for the double post, thought the first one did not go through....my bad

Well, think that might have identified the issue. The SIM was installed in slot 2 and the switch was down. However, when I went to look at the Main antenna connector port...and re-seat the antenna wires....the connector on the modem came off, guess it was not installed correctly as this is a new bui...

Help, First build. I put together a router using an EM 7565 and NEXG H721 router. Everything seems to have installed, router sees the modem. Firmware is up to date for both router and modem. I'm using an ATT SIM on an unlimited plan that was activated on an S7 and I even switched into another S7.......

OK, first time builder. I paired an EM 7565 with the NEXG H721 from this site, followed all instructions. Modem is recognized/present, but I can't get it to connect so not getting any internet. The SIM I am using is ATT on an unlimited plan. It is activated through an S7 and works on that phone with...