Search found 9 matches

Return

by Didneywhorl
Mon Apr 02, 2018 1:14 pm
Jump to forum
Jump to topic

NEXP1GO (WG3526-P) Router w/Sierra MC7455 Modem inside a WiFiX 19dBi Antenna Enclosure

Ok, so I'm going to post a butt ton of pictures here on how I put together a WG3526-P Router w/Sierra MC7455 Modem inside a DM25X19 Antenna. The pictures will be posted on this thread as a series of posts instead of one SUPER long single posting. NOTE: It is recommended to build and configure the WG...
by Didneywhorl
Mon May 11, 2020 5:29 pm
Jump to forum
Jump to topic

Re: What Modem should I use to replace coolpad hotspot from Mobile Citizen - sprint

All those are good to hook directly up to the enclosure, I believe. External, outdoor, antennas are a big discussion. I always recommend the highest gain antennas you can afford, always a pair if you can. I prefer directional flat panels. They are less picky as yagi type directionals, as they seem t...
by JimHelms
Mon Apr 06, 2020 5:25 pm
Jump to forum
Jump to topic

Re: EM7565 Verizon support

We have one Verizon unlimited data only reseller that we have worked for a couple of years. He said a few days ago that he still had a few slots open.

If you will reach out to us on the store via email, we will send you his contact info.
by BillA
Sun May 31, 2020 3:43 am
Jump to forum
Jump to topic

Re: Powering EM20-G in adapter enclosure

Why not just install the modem into the router? It would be much simpler, unless you want to install the modem/enclosure at a remote location (you didn't specify). In that case you would need to plug a USB3 hub into the router with a minimum 2amp power adapter for the hub, then plug then modem/enclo...
by BillA
Sun May 31, 2020 3:07 am
Jump to forum
Jump to topic

Re: Using 4 4G LTE antennas in WG3526 (with EM20-G)

Unfortunately you can't reuse the existing WiFi antennas/cables since they are soldered onto the main board, but you can reuse two of their holes. Here's a couple of ways to do it. If you're only using WiFi 2G or 5G at a time, then you could use the existing holes of the unused WiFi antennas to add ...
by BillA
Wed Feb 19, 2020 12:05 pm
Jump to forum
Jump to topic

Re: Quectel EP06-A AT commands for carrier aggregation bandlock?

Hello, Was looking thru the info on the link in this chat. Showing the AT commands for the Quectel EP06-A AT commands for bandlock. I have the Quectel EC25-AF. Does anyone know if the AT commands are the same on it as the Quectel EP06-A? Enter the following AT commands, and write down your original...
by bjames
Wed Jun 17, 2020 4:43 pm
Jump to forum
Jump to topic

Re: EM20-G won't connect. Please help

I notice the router is passing the APN "r.ispsn" to the modem so I assume you are using Sprint.

I seem to remember the Quectel modems need to be placed in LTE only to use with Sprint.

Code: Select all

AT+QCFG="nwscanmode",3,1
by Viper67857
Thu Jun 18, 2020 12:13 am
Jump to forum
Jump to topic

Re: EM20-G won't connect. Please help

CPBR reads phone book entries... Not sure why it's even attempting that, but it's probably erroring due to an empty phone book..? C5GREG might be a typo for CGREG, which just checks GPRS registration, or it might be for 5G, which the EM-20 doesn't support. Either way, it can be ignored since no one ...
by Didneywhorl
Tue May 31, 2022 8:43 am
Jump to forum
Jump to topic

Re: Switched from Sprint SIM to T-Mobile SIM (Calyx), but can't connect. CME ERROR: 13

Did you modify the modem to match the identity of the hotspot? It seems to be a requirement now.